|
Sikafloor 3 QuartzTop
(Formerly Chapdur Premix)
彩色矿物骨料干撒式地面硬化剂
Coloured Mineral Dry Shake Floor Hardener |
|
|
| Sika地面硬化剂简介(Produt Description) |
|
Sikafloor 3 QuartzTop是用于混凝土的预伴彩色矿物干撒式地面硬化剂，由精选的矿物骨料、水泥、特殊添加剂及颜色组成。
Sikafloor 3 QuartzTop is a preblended coloured mineral dry shake hardener for concrete comprising of specially selected quartz mineral aggregates, cements, compatible admixtures and pigment. |
|
|
| Sika地面硬化剂使用(Uses) |
|
* Sikafloor 3 QuartzTop为整体地坪提供坚硬耐磨的矿物干撒面层。撒播并打磨施工到新鲜湿润的混凝土地坪，即形成平滑的彩色耐磨表面。
* 特别适用于仓库、工厂、购物中心、公共场所、宾馆和博物馆等场所的整体地坪。
* Sikafloor 3 QuartzTop provides a hard wearing, mineral dry shake topping for monolithic follrs. When sprinkled and trowelled into fresh wet concrete floors, it forms a coloured, wear resistant smooth surface.
* Typical uses are in warehouses, factories, Shopping malls, public areas.restaurants and museums. |
|
|
| Sika地面硬化剂优点(Characteristics/Advantages) |
|
* 高度耐磨
* 抗冲击
* 节约成本、使用期限长
* 防尘
* 容易清洁
* 提高抗油及油脂性能
* 颜色多样
* 封住混凝土中的纤维
* Good wear resistance rating
* Impact resistance
* Cost effective surface hardener
* Dust proof
* East proof
* Increased resistance to oils and grease
* Quality assured factory blending
* Wide range of colours
* Suppresses fibres in concrete |
|
|
|
|
| Sika地面硬化剂数据(Product Data) |
|
| 形 态 |
粉 料 |
| 颜 色 |
原色（水泥灰）；其他颜色按要求而定 |
| 包装 |
25kg/袋 |
| 储存期 |
原装密封，可保存一年 |
| 储存条件 |
储存于阴凉（+5℃~+30℃）、干燥的地方且防潮 |
| 耐磨性 |
Class“AR2”高度耐磨（BS 8204） |
|
|
Tests
Approval/Standards |
Conforms to the requirements of BS 8204 |
| Form |
Powder |
| Colours |
Natural
Other colours available on request. |
| Packaging |
25kg bags |
Storage Conditions/
Shelf-Life |
12 months from date of production if stored in undamaged original sealed containers in dry conditions at temperatures between+5℃-and +30℃ |
| Abrasion Resistance |
Class”AR2”High Abrasion Resistance(BS8204) |
|
|
|
|
|
| Sika地面硬化剂施工须知(Information Application Details) |
|
用 量
(Consumption) |
约5kg/m2
Approx 5kg/m2 |
基面要求
(Substrate Quality) |
底层混凝土必须质地坚固。塌落度须在75~110mm 之间，效果最佳。
需采用水灰比最小的混凝土，并在浇捣时完全压实�？寡骨慷刃柙�25N/mm 2以上
。建议使用Sikament 或Sika ViscoCrete增塑剂确保最佳的混凝土质量；若使用纤维则在混合过程中应尽量打散。
The concrete should be of consistent quality.
Aconcrete slump in the range 75 to 110mm will normally give best resuits.
The slab should be of good quality concrete with a minimum water/cement
ratio consistent with the production of a fully compacted slab the compressive
strength should be a minimum of 25 N/mm2. The use of Sikament or Sika ViscoCrete
super plasticisers is advised to ensure the optimum quality of concrete and where
fibres are used , maximum dispersion within the mix. |
施工条件和限制
(Application Conditions/Limits) |
|
| 基面温度 |
最低： +5℃； 最高： +35℃
+5℃ min; +35℃ max |
环境温度
(Air Temperature) |
最低： +5℃； 最高： +35℃
+5℃ min; +35℃ max. |
相对空气湿度
(Reiative Air Humidity) |
最低： 30%； 最高： 98%
0%RH min; 98%RH max. |
|
|
|
|
|
| Sika地面硬化剂施工指引(Application Instructions) |
|
施工方法/工具(Application Method/Instrument)
接有激光刮板的自动撒播器；
找平后，立即将Sikafloor 3 QuartzTop按5kg/m2用量，一次性均匀撒播在混凝土上。
手工施工：待表面析出的水蒸发，将Sikafloor 3 QuartzTop分两次（第一次：3kg/m2；第二次2kg/m2；）均匀地撒播到找平的混土上。施工粉末时应小心，避免混凝土表面形成坑洼。施工总用量为5kg/m2。若不注意或向离撒播点2m以外抛洒Sikafloor 3 QuartzTop，都将减底终面层的一致性。
压实：第一次撒播的材料抹入地板后，立即撒播第二次份量的Sikafloor 3 QuartzTop。Sikafloor 3 QuartzTop使混凝土板表面硬化得比平常要快。小心修整将要浇捣的邻接边角�？捎梦锕せ虻缍ǖ督惺展�，封闭孔隙及修平表面。
Automatic spreader in conjunction with a laser screed;
Spread Sikafloor 3 QuartzTopevenly onto the concrete immediately after screeding at 5kg/m2 in one application.
Manual application;
Allow the surface bleed water to evaporate,Sprinkle Sikafloor 3 QuartzToponto the screeded concrete evenly in 2 stages（first stage：3kg/m2；second stage2kg/m2；）Care should be taken to apply the powder to avoid creating ripples etc. In the concrete surface. Overall application rate 5kg/m2。Casting Sikafloor 3 QuartzTop powder carelessly or further than 2 metres from point of casting will reduce the consistency of finish.
Compaction;
The first stage should be worked into the slab followed immediately with the sprinking on of the second measurement of Sikafloor 3 QuartzTop。
Sikafloor 3 QuartzTopresults in the slab surface becoming stiff more quickly than usual, Careful trimming should take place along the edges where adjoining siabs are to be poured.
Final finishing to close pores and remove undulations can be achieved either by hand or powered trowel. |
|
|
|
|
| Sika地面硬化剂施工注意事项(Notes on application Limits) |
|
干撒粉料的施工应在风或气流太大的地方进行�；炷粱娴奶匦匀纾汉屎退嘀柿炕嵋鹎嵛⑸�。对该系统而言，干固过程中的颜色变化属正常且应该的。由于基面混凝土天然的差异，干撒式硬化剂给整个混凝土地板的终饰面会有一些色差。相对湿度较低时，有风化的危险。相对湿度较高时，可能会析水，固化，硬化较慢，延迟收光操作。
The application of the dry shake powder should not be carried out in strong draughts.
Concrete substrate characteristics such as water content and cement quality may induce slight colour variations.
Colour variation during the drying our period is normal for this system and is to be expected.
Dry shake hardeners give a finish to concrete with some colour variation acrossthe floor dur to the natural variability of the concrete onto which the concrete onto which they are applied.
At low relative humidities there is a risk of efflorescence.
At high relative humidities there is a risk of beeding, slower curing, hardening and extended finishing operations. |
|
|
|
|
| 接 缝(Joints) |
|
地坪收光后立即用Sikafloor ProSeal 22（参考产品说明书）封闭和养护Sikafloor 3 QuartzTop。
启用时间：
| 基面温度 |
+10℃ |
+20℃ |
+30℃ |
| 可步行 |
18小时 |
12小时 |
8小时 |
| 完全投入使用 |
10天 |
7天 |
5天>/td>
|
上述数值取决于混凝土达到设计的使用强度，并受环境条件变化影响。
Applied product ready For use;
| Substrate Temperature |
+10℃ |
+20℃ |
+30℃ |
| Foot Traffic |
18hrs |
12hrs |
8hrs |
| Fully Serviceable |
10days |
7days |
5days |
The above values are dependant upon the concrete reaching its design strength for serviceability and will be affected by changing amient conditions。 |
|
|
|
|
| 地方限制(Local restrictions) |
|
请注意，由于当地规范不同，不同国家该产品的性能可能会有所差异。请参阅当地的产品说明书关于应用方面授准确描述。
Please note that as a result of specific local regulations the performance of this product may vary from country to country. Please consult the local Product Data Sheet for the exact description of the application fields. |
|
|
|
|
| 防护措施(Health and Dafety Information Protective Measures) |
|
在密闭的房间、矿井或竖井内施工，必须保证足够的通风。远离明火，包括焊接。为避免少量的过敏反应，建议使用丁基或丁晴橡胶手套。更换沾污的工作服，施工间歇和施工完毕要洗手。必须遵守当地规则和包装标签所示的健康和安全建议。
During application in closed roons, pits and shafts, etc. Sufficient ventilation must be provided. Keep away open light including welding.
To avoid rare allergic reactions, we recommend the use of butyl rubber/ nitril rubber gloves. Change soiled work clothes and wash hands before breaks and after finishing work.
Local regulations as well as heaith and safety advice on packaging labels must be observed. |
|
|
|
|
| 注意事项 |
|
按当地规定处理残留材料。完全固化的材料经当地负责机关同意后，可视同生活垃圾处理。详细的健康安全信息及预防撒施，如：物理、毒物学、生态学等数据，可参照安全指示说明书。 |
|
|
|
|
| Legal Notes |
|
The information, and in particular, the recommmendations relating to the application and end-use of Sika products, are given in good faith based on Sika’s current knowledge and experience of the products when properly stored, handled and applied under normal conditions, iIn practice, the differences in materialsm substrates and actual site conditions are such that no warranty in respect of merchantability or of fitness for a particular purpose, nor any liability arising out of any legal relationship whatsoever, can be inferred either from this information, or from any written recommendations, or from any other advice offered. The proprietary rights of third parties must be observed. All orders are accepted subject to our current terms of sale and delivery. Users should always refer to the most recent issue of the product Data Sheet for the product concerned, copies of which will be supplied on request. |
|
|
|
|
